Tags

msm-next for v6.4

Early pull req with PSR and related drm core helpers

msm-fixes for v6.3-rc2

- Fix for possible invalid ptr free in submit ioctl syncobj cleanup path.
- Synchronize GMU removal in driver teardown path
- a5xx preemption fixes
- Fix runpm imbalance at unbind
- DPU hw catalog fixes:
 - set DPU_MDP_PERIPH_0_REMOVED for sc8280xp as this is another chipset
   where the PERIPH_0 block of registers is not there
 - fix the DPU features supported in QCM2290 by comparing it with the
   downstream device tree
 - fix the length of registers in the sc7180_ctl from 0xe4 to 0x1dc
 - fix the max mixer line width for sm6115 and qcm2290 chipsets in the
   DPU catalog
 - fix the scaler version on sm8550, sc8280xp, sm8450, sm8250, sm8350
   and sm6115. This was incorrectly populated on the SW version of the
   scaler library and  not the scaler HW version
 - Drop dim layer support for msm8998 as its not indicated to be
   supported in the downstream DTSI
 - fix the DPU_CLK_CTRL bits for msm 8998 sspp blocks
 - Use DPU_CLK_CTRL_DMA* prefix instead of DPU_CLK_CTRL_CURSOR*
   for all chipsets for the DMA sspp blocks
 - fix the ping-pong block base address for sc7280 in the DPU HW catalog
- Fix stack corruption issue in the dpu_hw_ctl_setup_blendstage() function
  as it was causing a negative left shift by protecting against an invalid
  index
- Clear the DSPP reservations in dpu_rm_release(). This was missed out and
  as as result the DSPP was not released from the resource manager global
  state.

msm-next for v6.3

There is one devfreq patch, maintainer acked to land via msm-next to
avoid a build break on platforms that do not support PM_DEVFREQ.  And
otherwise the usual assortment:

GPU:
- Add MSM_SUBMIT_BO_NO_IMPLICIT
- a2xx: Support to load legacy firmware
- a6xx: GPU devcore dump updates for a650/a660
- GPU devfreq tuning and fixes

DPU, DSI, MDSS:
- Support for SM8350, SM8450 SM8550 and SC8280XP platform

Core:
- Added bindings for SM8150 (driver support already present)

DPU:
- Partial support for DSC on SM8150 and SM8250
- Fixed color transformation matrix being lost on suspend/resume
- Include DSC blocks into register snapshot
- Misc HW catalog fixes

DP:
- Support for DP on SDM845 and SC8280XP platforms
- HPD fixes
- Support for limiting DP link rate via DT property, this enables
- Support for HBR3 rates.

DSI:
- Validate display modes according to the DSI OPP table
- DSI PHY support for the SM6375 platform
- Fixed byte intf clock selection for 14nm PHYs
- Fix the case of empty OPP tables (fixing db410c)
- DT schema rework and fixes

HDMI:
- Turn 8960 HDMI PHY into clock provider,
- Make 8960 HDMI PHY use PXO clock from DT

MDP5:
- Schema conversion to YAML

msm-fixes for v6.3-rc5

Two GPU fixes which were meant to be part of the previous pull request,
but I'd forgotten to fetch from gitlab after the MR was merged so that
git tag was applied to the wrong commit.

- kexec shutdown fix
- fix potential double free

msm-fixes for v6.3-rc4

Display Fixes:

- Fix the documentation for dpu_encoder_phys_wb_init() and
  dpu_encoder_phys_wb_setup_fb() APIs to address doc warnings
- Remove vcca-supply and vdds-supply as mandatory for 14nm PHY and
  10nm PHY DT schemas respectively as they are not present on some
  SOCs using these PHYs
- Add the dsi-phy-regulator-ldo-mode to dsi-phy-28nm.yaml as it was
  missed out during txt to yaml migration
- Remove operating-points-v2 and power-domain as a required property
  for the DSI controller as thats not the case for every SOC
- Fix the description from display escape clock to display core
  clock in the dsi controller yaml
- Fix the memory leak for mdp1-mem path for the cases when we return
  early after failing to get mdp0-mem ICC paths for msm
- Fix error handling path in msm_hdmi_dev_probe() to release the phy
  ref count when devm_pm_runtime_enable() fails
- Fix the dp_aux_isr() routine to make sure it doesnt incorrectly
  signal the aux transaction as complete if the ISR was not an AUX
  isr. This fixes a big hitter stability bug on chromebooks.
- Add protection against null pointer dereference when there is no
  kms object as in the case of headless adreno GPU in the shutdown
  path.

GPU Fixes:

- a5xx: fix quirks to actually be a bitmask and not overwrite each
  other
- a6xx: fix gx halt sequence to avoid 1000ms hang on some devices
- kexec shutdown fix
- fix potential double free

msm-next for v6.2 (the gpu/gem bits)

- Remove exclusive-fence hack that caused over-synchronization
- Fix speed-bin detection vs. probe-defer
- Enable clamp_to_idle on 7c3
- Improved hangcheck detection

drm/msm updates for 6.2

Core:
- MSM_INFO_GET_FLAGS support
- Cleaned up MSM IOMMU wrapper code

DPU:
- Added support for XR30 and P010 image formats
- Reworked MDSS/DPU schema, added SM8250 MDSS bindings
- Added Qualcomm SM6115 support

DP:
- Dropped unsane sanity checks

DSI:
- Fix calculation of DSC pps payload

DSI PHY:
- DSI PHY support for QCM2290

HDMI:
- Reworked dev init path

msm-fixes for v6.1

- Fix shrinker deadlock
- Fix crash during suspend after unbind
- Fix IRQ lifetime issues
- Fix potential memory corruption with too many bridges
- Fix memory corruption on GPU state capture

msm-next for v6.1

DPU:
- simplified VBIF configuration
- cleaned up CTL interfaces to accept indices rather than flush masks

DSI:
- removed unused msm_display_dsc_config struct
- switch regulator calls to new bulk API
- switched to use PANEL_BRIDGE for directly attached panels

DSI PHY:
- converted drivers to use parent_hws instead of parent_names

DP:
- cleaned up pixel_rate handling

HDMI PHY:
- turned hdmi-phy-8996 into OF clk provider

core:
- misc dt-bindings fixes
- choose eDP as primary display if it's available
- support getting interconnects from either the mdss or the mdp5/dpu
  device nodes

gpu+gem:
- Shrinker + LRU re-work:
  - adds a shared GEM LRU+shrinker helper and moves msm over to that
  - reduces lock contention between retire and submit by avoiding the
    need to acquire obj lock in retire path (and instead using resv
    seeing obj's busyness in the shrinker
  - fix reclaim vs submit issues
- GEM fault injection for triggering userspace error paths
- Map/unmap optimization
- Improved robustness for a6xx GPU recovery

Fixes for v6.0

- Fix for inconsistent indenting in function msm_dsi_dphy_timing_calc_v3.
  This fixes a smatch warning reported by kbot
- Fix to make eDP the first connector in the connected list. This was
  mainly done to address a screen corruption issue we were seeing on
  sc7280 boards which have eDP as the primary display. The corruption
  itself is from usermode but we decided to fix it this way because
  things work correct with the primary display as the first one for
  usermode
- Fix to populate intf_cfg correctly before calling reset_intf_cfg().
  Without this, the display pipeline is not torn down correctly for
  writeback
- Specify the correct number of DSI regulators for SDM660. It should
  have been 1 but 2 was mentioned
- Specify the correct number of DSI regulators for MSM8996. It should
  have been 3 but 2 was mentioned
- Fix for removing DP_RECOVERED_CLOCK_OUT_EN bit for tps4 link training
  for DP. This was causing link training failures and hence no display
  for a specific DP to HDMI cable on chromebooks
- Fix probe-deferral crash in gpu devfreq
- Fix gpu debugfs deadlock

Next for v5.20

GPU:
- a619 support
- Fix for unclocked GMU register access
- Devcore dump enhancements

Core:

- client utilization via fdinfo support
- fix fence rollover issue
- gem: Lockdep false-positive warning fix
- gem: Switch to pfn mappings

DPU:

- constification of HW catalog
- support for using encoder as CRC source
- WB support on sc7180
- WB resolution fixes

DP:

- dropped custom bulk clock implementation
- made dp_bridge_mode_valid() return MODE_CLOCK_HIGH where applicable
- fix link retraining on resolution change

MDP5:

- MSM8953 perf data

HDMI:

- YAML'ification of schema
- dropped obsolete GPIO support
- misc cleanups

Fixes for v5.19-rc5

- Fix to increment vsync_cnt before calling drm_crtc_handle_vblank so that
  userspace sees the value *after* it is incremented if waiting for vblank
  events
- Fix to reset drm_dev to NULL in dp_display_unbind to avoid a crash in
  probe/bind error paths
- Fix to resolve the smatch error of de-referencing before NULL check in
  dpu_encoder_phys_wb.c
- Fix error return to userspace if fence-id allocation fails in submit
  ioctl

Fixes for v5.19-rc4

- Workaround for parade DSI bridge power sequencing
- Fix for multi-planar YUV format offsets
- Limiting WB modes to max sspp linewidth
- Fixing the supported rotations to add 180 back for IGT
- Fix to handle pm_runtime_get_sync() errors to avoid unclocked access
  in the bind() path for dpu driver
- Fix the irq_free() without request issue which was a being hit frequently
  in CI.
- Fix to add minimum ICC vote in the msm_mdss pm_resume path to address
  bootup splats
- Fix to avoid dereferencing without checking in WB encoder
- Fix to avoid crash during suspend in DP driver by ensuring interrupt
  mask bits are updated
- Remove unused code from dpu_encoder_virt_atomic_check()
- Fix to remove redundant init of dsc variable
- Fix to ensure mmap offset is initialized to avoid memory corruption
  from unpin/evict
- Fix double runpm disable in probe-defer path
- VMA fenced-unpin fixes
- Fix for WB max-width
- Fix for rare dp resolution change issue